Vincent 1951 rapide 1000cc 2 cyl ohv 2706

€ 59.500
Provincie
Prijs:
€ 59.500
Sinds:
3 maanden+
Gezien:
1.612 keer
Plaats:
Nederweert, LB
Adverteerder:
Yesterdays
Telefoon:
0495-546054
Activiteit:
13 jaar actief op Marktnet
Positie
51.28595,5.747913
Yesterdays
Vincent 1951 rapide 1000cc 2 cyl ohv 2706
Versturen

Alle velden zijn verplicht

Vincent 1951 rapide 1000cc 2 cyl ohv 2706

Vincent 1951 Rapide 998cc Upper Frame nr RC/1/8826/C Rear Frame nr RC7469  Engine nrF10AB/1/5569
The outbreak of WW2 in 1939 brought production of all Series A models to a halt, and when Vincent resumed production at the war’s end it was with the all-new Series B. Its rear suspension aside, the Series A Vincent-HRD had been conventional enough: tubular steel frame, girder forks, separate gearbox, etc but with the Series B Messrs Vincent and Irving effectively established the marque’s reputation for the defiance of convention in the pursuit of engineering excellence. For a start there was no ‘frame’ as such, merely a fabricated box attached to the cylinder heads, that served as the oil tank and incorporated the headstock and the attachment point for the rear springs. The gearbox was integral with the engine, and the swinging arm pivoted directly in the engine/gearbox casings, features commonplace today but unusual 60 years ago. Only in his retention of the pre-war Brampton girder fork did Phillip Vincent appear to be lagging behind other manufacturers, almost all of which had switched to telescopics, but this apparent shortcoming would soon be addressed by the introduction of the famous ‘Girdraulic’ fork.
Introduced in 1946, the Vincent-HRD Series-B Rapide was immediately the fastest production motorcycle on sale anywhere, with a top speed of 110mph. The basic design clearly had even greater potential though, which would be realised later in the form of the Black Shadow and Black Lightning models.
In 1948 the Vincent range began to be up-dated to ‘Series C’ specification. The most significant changes made concerned the suspension, there being a revised arrangement at the rear incorporating curved lugs for the seat stays and an hydraulic damper between the spring boxes, while at the front the new models boasted Vincent’s own ‘Girdraulic’ fork: a blade-type girder fitted with twin hydraulic dampers. These advances began to find their way onto production models during 1948 but it would be 1950 before all Vincents left the factory in Series C specification. This particular Rapide has been painstakingly restored and runs beautiful.

Link: